Dell Force10 S4810P, Справочное руководство

Страница: 757 / 1637

24
Interfaces
The commands in this chapter are supported by Dell Force10 operating software (FTOS) on the E-Series, C-Series, S-
Series, S4810, or Z-Series platforms.
Although all interfaces are supported on E-Series ExaScale, some interface functionality is supported on E-Series
ExaScale with FTOS 8.2.1.0 and later. When this is the case, it is noted in the Command History section.
This chapter contains the following sections:
• Basic Interface Commands
• Port Channel Commands
• Time Domain Reflectometer (TDR)
• UDP Broadcast
Basic Interface Commands
The following commands are for Physical, Loopback, and Null interfaces.
clear counters
Clear the counters used in the show interfaces commands for all virtual router redundancy protocol (VRRP) groups,
virtual local area networks (VLANs), and physical interfaces, or selected ones.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax clear counters [ interface ] [vrrp [{[ipv6] vrid | vrf instance }]
| learning-limit]
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/port or
number to clear counters from a specified interface:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords
port-
channel
followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, 1 to 255 for
TeraScale and 1 to 512 for ExaScale.
• For the management interface on the RPM, enter the keyword
ManagementEthernet
followed by slot/port information.
The slot range is 0 to 1 and the port range is 0.
• For a SONET interface, enter the keyword
sonet
followed by
the slot/port information.
757