Dell Force10 S4810P, Справочное руководство

Страница: 134 / 1637

ip-address
(OPTIONAL) Enter the IPv4 address of the device to which you are
testing connectivity. The address must be in the dotted decimal
format.
ipv6-address
(OPTIONAL) E-Series only: Enter the IPv6 address, in the x:x:x:x::x
format, to which you are testing connectivity.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
count
Enter the number of echo packets to be sent. Default: 5.
• number: 1- 2147483647
• continuous: transmit echo request continuously
datagram size Enter the ICMP datagram size. Range: 36 - 15360 bytes. Default: 100.
timeout Enter the interval to wait for an echo reply before timing out. Range: 0
-3600 seconds. Default: 2 seconds.
source Enter the IPv4 or IPv6 source ip address or the source interface. For
IPv6 addresses, you may enter global addresses only. Enter the IP
address in A.B.C.D format.
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-
channel
followed by a number: For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• E-Series only: For the SONET interfaces, enter the keyword
sonet
followed by slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan
followed by a
number from 1 to 4094.
tos (IPv4 only) Enter the type of service required. Range: 0-255. Default: 0.
df-bit (IPv4 only) Enter
Y
or
N
for the “don't fragment” bit in IPv4 header.
•
N
: Do not set the “don't fragment” bit.
•
Y
: Do set “don't fragment” bit
Default is No.
validate-reply
(IPv4 only) Enter
Y
or
N
for reply validation.
•
N
: Do not validate reply data .
•
Y
: Do validate reply data .
134