Dell Force10 S4810P, Справочное руководство

Страница: 139 / 1637

• reset stack-unit – resets any designated stack member except the management unit.
reset
Reset a line card, RPM, or a failed SFM (TeraScale only).
C-Series, E-Series
Syntax reset {linecard number [hard | power-cycle] | rpm number [hard
| power-cycle] | sfm slot number }
Parameters
linecard
number
Enter the keyword
linecard
and a number for the line card slot
number. The C-Series range is 0 to 7. The E-Series range is 0 to 13 on
the E1200/E1200i, 0 to 6 on the E600/E600i, and 0 to 5 on the E300.
(Optional) Add the keyword
hard
or
power-cycle
(
power-
cycle
is C-Series only) to power cycle the line card.
hard Enter the keyword
hard
to power cycle the line card.
power-cycle Enter the keyword
power-cycle
after upgrading a C-Series FPGA
to cause the FPGA to be reprogrammed based on the contents of the
FPGA PROM.
NOTE: This option is supported on the C-Series only.
rpm number Enter the keyword
rpm
followed by a number for the RPM slot
number. Range: 0 to 1.
(Optional) Add the keyword
hard
or
power-cycle
(C-Series only)
to power cycle the RPM.
sfm
slot number
Enter the keyword
sfm
followed by the failed or powered-off SFM
slot number.
NOTE: Supported on the E-Series only.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information The command
reset
without any options is a soft reset, which means FTOS boots the line
card from its runtime image. The
hard
option reloads the FTOS image on the line card. Use the
power-cycle
command after upgrading an FPGA.
139