Dell Force10 S4810P, Справочное руководство

Страница: 252 / 1637

Parameters
protocol-type-
number Enter a number from 600 to FFFF as the specific Ethernet type traffic
to drop.
destination-mac-
address mac-
address-mask
Enter a MAC address and mask in the nn:nn:nn:nn:nn format.
For the MAC address mask, specify which bits in the MAC address
must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
any Enter the keyword
any
to match and drop specific Ethernet traffic on
the interface.
vlan
vlan-id
Enter the keyword
vlan
and then enter the VLAN ID to filter traffic
associated with a specific VLAN. The range is 1 to 4094 and 1 to 2094
for ExaScale ( you can use IDs 1 to 4094). To filter all VLAN traffic,
specify
VLAN 1
.
source-mac-
address mac-
address-mask
Enter a MAC address and mask in the nn:nn:nn:nn:nn format.
For the MAC address mask, specify which bits in the MAC address
must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
count (OPTIONAL) Enter the keyword
count
to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword
byte
to count bytes processed by
the filter.
log (OPTIONAL, E-Series only) Enter the keyword
log
to have the
information kept in an ACL log file.
order (OPTIONAL) Enter the keyword
order
to specify the QoS priority for
the ACL entry. The range is 0 to 254 (where 0 is the highest priority
and 254 is the lowest; lower order numbers have a higher priority) If
you did not use the keyword
order
, the ACLs have the lowest order
by default (255).
monitor (OPTIONAL) Enter the keyword
monitor
when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface. For more
information, refer to the section “Flow-based Monitoring” in the Port
Monitoring chapter of the
FTOS Configuration Guide
.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
252