Dell Force10 S4810P, Справочное руководство

Страница: 240 / 1637

any Enter the keyword
any
to specify that all routes are subject to the
filter.
host
ip-address
Enter the keyword
host
and then enter the IP address to specify a
host IP address only.
count (OPTIONAL) Enter the keyword
count
to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword
byte
to count bytes processed by
the filter.
log (OPTIONAL, E-Series only) Enter the keyword
log
to enter ACL
matches in the log.
dscp (OPTIONAL) Enter the keyword
dcsp
to match to the IP DCSCP
values.
order (OPTIONAL) Enter the keyword
order
to specify the QoS order of
priority for the ACL entry. The range is 0 to 254 (where 0 is the highest
priority and 254 is the lowest; lower order numbers have a higher
priority). The default is, if you do not use the keyword
order
, the
ACLs have the lowest order by default (255).
monitor (OPTIONAL) Enter the keyword
monitor
when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface.
NOTE: For more information, refer to the “Flow-based Monitoring”
section in the Port Monitoring chapter of the
FTOS Configuration
Guide
.
fragments Enter the keyword
fragments
to use ACLs to control packet
fragments.
Defaults Not configured.
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Add the DSCP value for ACL matching.
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Added support for the non-contiguous mask and added the
monitor
option.
Version 6.5.1.0 Expanded to include the optional QoS
order
priority for the ACL
entry.
240