Dell Force10 S4810P, Справочное руководство

Страница: 131 / 1637

linecard (4-port 40G line card)
Pre-configure an empty slot in an E-Series ExaScale switch for a 4-port 40 GigabitEthernet (40GE) line card or
reconfigure a slot in which you have hot-swapped a 4-port 40GE line card.
E-Series ExaScale Only
Syntax linecard slot-number card-type {linerate | oversubscribed}
active-ports port-set0 port-number [ port-number ] port-set1
port-number [ port-number ]
Parameters
slot-number Enter the slot number in which you will use the line card. The range is
0 - 13 on the E1200i and 0 - 5 on the E600i.
card-type Enter the line card ID. Valid values are:
• EX04PH: Configures the slot for a 6-port 40GE line card with
10M CAM (LC-EH-40GE-4P).
• EX04PJ: Configures the slot for a 6-port 40GE line card with
40M CAM (LC-EJ-40GE-4P).
linerate Configure two ports on the line card to transmit data at full line rate
(40 Gbps).
oversubscribed Configure four ports on the line card for oversubscribed data
transmission.
active-ports Enable the active ports for the specified mode (linerate or
oversubscribed).
port-set0
port-
number
[
port-
number
]
Enter the port number(s) used to specify the active ports on port pipe
0. Port-number range: 0 - 2.
On port pipe 0, 0 - 2 corresponds to ports 0, 1, and 2 on the line card. If
you configure linerate mode, enter one port number for port pipe 0.
If you configure oversubscribed mode, enter two port numbers
(separated by a space).
port-set1
port-
number
[
port-
number
]
Enter the port number(s) used to specify the active ports on port pipe
1. Port-number range: 0 - 2.
On port pipe 1, 0 - 2 corresponds to ports 3, 4, and 5 on the line card. If
you configure linerate mode, enter one port number for port pipe 1.
If you configure oversubscribed mode, enter two port numbers
(separated by a space).
Defaults When you insert a 4-port 40GE line card in an ExaScale slot, the line card is set to operate in
oversubscribed mode with active ports 1 and 2 on port pipe 0 (portset0 1 2) and active ports 0
and 1 on port pipe 1 (portset1 0 1).
Command Modes CONFIGURATION
Command History
Version 8.5.1.0 Introduced on the E-Series ExaScale E600i and E1200i.
131