Dell Force10 S4810P, Справочное руководство

Страница: 118 / 1637

Version 6.1.1.0 Values changed as described above.
Usage
Information Save the configuration and reload the chassis for the changes to the
epoch
command setting
to take affect.
When using ten SFMs in an ExaScale chassis, the
10.4
and
2.4
settings are both line rate.
Additionally, the
2.4
setting has a lower latency.
When using nine SFMs in an ExaScale chassis, the
10.4
setting is line rate and the
2.4
setting reduces throughput. When the system has nine SFMs, Dell Force10 recommends using
the
10.4
setting.
Using eight SFMs in an ExaScale chassis reduces throughput at any epoch setting.
NOTE: The E300 supports only the
10.4
epoch setting. The E-Series TeraScale E600/E600i
and the E1200/E1200i systems support the
10.4
and
3.2
epoch settings.
NOTE: For E-Series ExaScale, the
2.4
setting is supported on FTOS version 8.3.1.0 and
later. The
10.4
setting is supported on all ExaScale FTOS versions. The
3.2
setting is
only supported on FTOS versions 8.2.1.0 and earlier.
exec-banner
Enable the display of a text string when the user enters EXEC mode.
C-Series, E-Series, S-Series, Z-Series
Syntax exec-banner
To disable the banner on terminal lines, use the
no exec-banner
command.
Defaults Enabled on all lines (if configured, the banner appears).
Command Modes LINE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information Optionally, use the
banner exec
command to create a text string that is displayed when you
access EXEC mode. This command toggles that display.
Related
Commands
banner exec – configures a banner to display when entering EXEC mode.
line – enables and configures console and virtual terminal lines to the system.
118