Dell Force10 S4810P, Справочное руководство

Страница: 929 / 1637

2 port-set 1
Linecard|Portpipe| CAM Partition|Available CAM|Estimated CAM
per Port|Status
---------------------------------------------------------------
--
2| 1| IPv4Flow| 232| 0|
Allowed
2| 1| IPv6Flow| 0| 0|
Allowed
FTOS#
IPv6 Route Map Commands
The following commands allow you to configure route maps and their redistribution criteria.
match ipv6 address
Configure a filter to match routes based on IPv6 addresses specified in an access list.
C-Series, E-Series, S-Series
Syntax match ipv6 address prefix-list-name
To delete a match, use the
no match ipv6 address prefix-list-name
command.
Parameters
prefix-list-name Enter the name of IPv6 prefix list, up to 140 characters.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series. Increased the name string to accept up
to 140 characters. Prior to version 7.8.1.0, the names are up to 16
characters long.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Related
Commands
match ipv6 next-hop – redistributes routes that match the next-hop IP address.
match ipv6 route-source – redistributes routes that match routes advertised by other routers.
match ipv6 next-hop
Configure a filter which matches based on the next-hop IPv6 addresses specified in the IPv6 prefix list.
C-Series, E-Series, S-Series
Syntax match ipv6 next-hop prefix-list prefix-list-name
929