Dell Force10 S4810P, Справочное руководство

Страница: 200 / 1637

Command History
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series and expanded to support command
history, hardware trace, and software trace logs.
Version 6.1.1.0 Introduced on the E-Series.
Usage
Information The log information is uploaded to
flash:/TRACE_LOG_DIR
.
virtual-ip
Configure a virtual IP address for the active management interface. Virtual addresses can be configured both for IPv4
and IPv6 independently.
C-Series, E-Series, Z-Series
Syntax virtual-ip { ipv4-address | ipv6-address }
To return to the default, use the
no virtual-ip { ipv4-address | ipv6-
address }
command.
Parameters
ipv4-address
Enter the IP address of the active management interface in a dotted
decimal format (A.B.C.D.).
ipv6-address
Enter an IPv6 address of the active management interface, in the
x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.0.0.0 Introduced on the Z9000
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only one of each.
Each time this command is issued, it replaces the previously configured address of the same
family, IPv4 or IPv6. The
no virtual-ip
command takes an address/prefix-length
argument, so that the desired address only is removed. If you enter the
no virtual-ip
command without any specified address, then both IPv4 and IPv6 virtual addresses are
removed.
200