Dell Force10 S4810P, Справочное руководство

Страница: 745 / 1637

Defaults 10 seconds
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to enable the
system to act as an IGMP Proxy Querier.
Version 7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to enable the
system to act as an IGMP Proxy Querier.
E-Series legacy
command.
ip igmp ssm-map
Use a statically configured list to translate (*,G) memberships to (S,G) memberships.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip igmp ssm-map std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them with (*,G)
state, use the
ip igmp ssm-map std-access-list source-address
command.
Parameters
std-access-list
Specify the standard IP access list that contains the mapping rules
for multicast groups.
source-address
Specify the multicast source address to which the groups are
mapped.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.7.1.0 Introduced on the E-Series.
Usage
Information Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in the
IGMP groups. You may not use extended access lists with this command. When you configure
a static SSM map and the router cannot find any matching access lists, the router continues to
accept (*,G) groups.
Related
Commands ip access-list standard – creates a standard access list to filter based on IP address.
745