Dell Force10 S4810P, Справочное руководство

Страница: 1209 / 1637

hold-interval Set the next interval to send the same LSA. This is the time between
sending the same LSA after the start-interval has been attempted.
The range is 1 to 600,000 milliseconds.
max-interval Set the maximum amount of time the system waits before sending the
LSA. The range is 1 to 600,000 milliseconds.
Defaults
• start-interval : 0 msec
• hold-interval : 5000 msec
• max-interval : 5000 msec
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information LSAs are sent after the start-interval and then after hold-interval until the maximum interval is
reached. In throttling, exponential backoff is used when sending same LSA, so that the interval
is multiplied until the maximum time is reached. For example, if the
start-interval 5000
and
hold-
interval 1000
and
max-interval 100,000
, the LSA is sent at 5000 msec, then 1000 msec, then 2000
msec, them 4000 until 100,000 msec is reached.
timers throttle lsa arrival
Configure the LSA acceptance intervals.
Z-Series, S4810
Syntax timers throttle lsa arrival arrival-time
To return to the default, use the
no timers throttle lsa
command.
Parameters
arrival-time
Set the interval between receiving the same LSA repeatedly, to allow
sufficient time for the system to accept the LSA. The range is 0 to
600,000 milliseconds.
Defaults 1000 msec
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
1209