Dell Force10 S4810P, Справочное руководство

Страница: 772 / 1637

Version 8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale. Prior releases
supported 2094.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Usage
Information When creating an interface range, interfaces appear in the order they are entered; they are not
sorted. The command verifies that interfaces are present (physical) or configured (logical).
Important Things to Remember:
• Bulk configuration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk configuration with a warning
message.
• The
interface range
prompt includes interface types with slot/port information
for valid interfaces. The prompt allows for a maximum of 32 characters. If the bulk
configuration exceeds 32 characters, it is represented by an ellipsis ( ... ).
• When the
interface range
prompt has multiple port ranges, the smaller port
range is excluded from the prompt.
• If overlapping port ranges are specified, the port range is extended to the smallest
start port and the biggest end port.
Example (Bulk)
FTOS(conf)#interface range so 2/0-1, te 10/0, gi 3/0, fa 0/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example (Multiple
Ports)
FTOS(conf)#interface range gi 2/0 - 23, gi 2/1 - 10
FTOS(conf-if-range-gi-2/0-23#
Example
(Overlapping
Ports)
FTOS(conf)#interface range gi 2/1 - 11, gi 2/1 - 23
FTOS(conf-if-range-gi-2/1-23#
Usage
Information
Only VLAN and port-channel interfaces created using the
interface vlan
and
interface port-channel
commands can be used in the
interface range
command.
Use the
show running-config
command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the
show running-
config
command can not be used with the bulk configuration feature of the
interface
range
command. You cannot create virtual interfaces (VLAN, Port-channel) using the
interface range
command.
NOTE: If a range has VLAN, physical, port-channel, and SONET interfaces, only commands
related to physical interfaces can be bulk configured. To configure commands specific to
VLAN, port-channel, or SONET, only those respective interfaces should be configured in a
particular range.
772