Dell Force10 S4810P, Справочное руководство

Страница: 1067 / 1637

32
Link Layer Discovery Protocol (LLDP)
Link layer discovery protocol (LLDP) advertises connectivity and management from the local station to the adjacent
stations on an IEEE 802 LAN.
This chapter contains the following sections:
• LLPD Commands
• LLDP-MED Commands
LLDP facilitates multi-vendor interoperability by using standard management tools to discover and make available a
physical topology for network management. The Dell Force10 operating software (FTOS) implementation of LLDP is
based on IEEE standard 801.1ab.
The basic LLDP commands are supported by FTOS on all C-Series, E-Series, S-Series, Z-Series, or S4810 Dell Force10
systems.
The starting point for using LLDP is invoking LLDP with the
protocol lldp
command in either CONFIGURATION or
INTERFACE mode.
The information distributed by LLDP is stored by its recipients in a standard management information base (MIB). You
can access the information by a network management system through a management protocol such as simple network
management protocol (SNMP).
LLPD Commands
The following are LLDP commands.
advertise dot1-tlv
Advertise dot1 TLVs (Type, Length, Value).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax advertise dot1-tlv {port-protocol-vlan-id | port-vlan-id |
vlan-name}
To remove advertised dot1-tlv, use the
no advertise dot1-tlv {port-protocol-
vlan-id | port-vlan-id | vlan-name}
command.
Parameters
port-protocol-
vlan-id Enter the keywords
port-protocol-vlan-id
to advertise the
port protocol VLAN identification TLV.
port-vlan-id Enter the keywords
port-vlan-id
to advertise the port VLAN
identification TLV.
vlan-name Enter the keywords
vlan-name
to advertise the vlan-name TLV.
This keyword is only supported on the C-Series and S-Series.
1067