Dell Force10 S4810P, Справочное руководство

Страница: 1262 / 1637

ipv6 pim rp-address
Configure a static PIM rendezvous point (RP) address for a group. This address is used by first-hop routers to send
register packets on behalf of the source multicast host.
E-Series, S4810
Syntax ipv6 pim rp-address address group-address group-address mask
override
To remove an RP address, use the
no ipv6 pim re-address address group-
address mask override
command.
Parameters
address
Enter the IPv6 RP address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zero.
group-address
group-address
mask
Enter the keywords
group-address
followed by the group
address in the x:x:x:x::x format and then the mask in /nn format to
assign that group address to the RP.
NOTE: The :: notation specifies successive hexadecimal fields of
zero.
override Enter the keyword
override
to override the BSR updates with
static RP. The override takes effect immediately during enable/
disable.
NOTE: This option is applicable to multicast group range.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
Usage
Information
The RP addresses are stored in the order in which they are entered. RP addresses learnt via
BSR take priority over static RP addresses.
Without the override option, RPs advertised by the BSR updates take precedence over the
statically configured RPs.
ipv6 pim rp-candidate
Specify an interface as an RP candidate.
E-Series, S4810
Syntax ipv6 pim rp-candidate interface [ priority-value ]
1262