Dell Force10 S4810P, Справочное руководство

Страница: 763 / 1637

disable-on-sfm-failure
Disable select ports on E300 systems when a single switch fabric modules (SFM) is available.
E-Series
Syntax disable-on-sfm-failure
To delete a description, use the
no disable-on-sfm-failure
command.
Defaults Port is not disabled.
Command Modes INTERFACE
Command History
Version 7.7.1.0 Introduced on the E300 systems only.
Usage
Information
When an E300 system boots up and a single SFM is active on this configuration, any ports you
configure with this feature are shut down. If an SFM fails (or you remove) in an E300 system
with two SFM, the ports you configure with this feature are shut down. All other ports are
treated normally.
When you install or replace a second SFM, all ports are booted up and treated as normally.
This feature does not take affect until a single SFM is active in the E300 system.
duplex (Management)
Set the mode of the Management interface.
C-Series, E-Series, Z-Series
Syntax duplex {half | full}
To return to the default setting, use the
no duplex
command.
Parameters
half Enter the keyword
half
to set the Management interface to transmit
only in one direction.
full Enter the keyword
full
to set the Management interface to transmit
in both directions.
Defaults Not configured.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Documentation modified—added
Management
to distinguish from
duplex (10/100 Interfaces)
.
763