Dell Force10 S4810P, Справочное руководство

Страница: 613 / 1637

service-policy output
command), the QoS configuration in the output policy takes
precedence.
Related
Commands
• dcb-output – creates a DCB output policy.
• dcb-policy output – applies the output policy.
priority-list
Configure the 802.1p priorities for the traffic on which you want to apply an ETS output policy.
S4810
Syntax priority-list value
To remove the priority list, use the
no priority-list
command.
Parameters
value
Enter the priority list value. Separate priority values with a comma;
specify a priority range with a dash; for example, priority-list 3,5-7.
The range is 0 to 7.
Defaults none
Command Modes PRIORITY-GROUP
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information By default:
• All 802.1p priorities are grouped in priority group 0.
• 100% of the port bandwidth is assigned to priority group 0. The complete bandwidth is
equally assigned to each priority class so that each class has 12 to 13%.
Related
Commands
• priority-group – creates an ETS priority group.
• priority-group qos-policy – associates an ETS priority group with an ETS output policy.
• set-pgid – configures the priority-group.
priority-group
Create an ETS priority group to use with an ETS output policy.
S4810
Syntax priority-group group-name
To remove the priority group, use the
no priority-group
command.
Parameters
group-name
Enter the name of the ETS priority group. The maximum is 32
characters.
613