Dell Force10 S4810P, Справочное руководство

Страница: 627 / 1637

Parameters
auto | cee | cin |
ieee-v2.5 Enter the DCBX version type used on the interface, where:
•
auto
: configures the port to operate using the DCBX version
received from a peer.
•
cee
: configures the port to use CDD (Intel 1.01).
•
cin
: configures the port to use Cisco-Intel-Nuova (DCBX
1.0).
•
ieee-v2
: configures the port to use IEEE 802.1az (Draft 2.5).
Defaults Auto
Command Modes INTERFACE PROTOCOL LLDP
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To
verify the DCBX configuration on a port, use the
show interface dcbx detail
command.
debug dcbx
Enable DCBX debugging.
S4810
Syntax debug dcbx {all | auto-detect-timer | config-exchng | fail |
mgmt | resource | sem | tlv}
To disable DCBX debugging, use the
no debug dcbx
command.
Parameters
{all | auto-detect-
timer | config-
exchng | fail |
mgmt | resource |
sem | tlv} Enter the type of debugging, where:
•
all
: enables all DCBX debugging operations.
•
auto-detect-timer
: enables traces for DCBX auto-
detect timers.
•
config-exchng
: enables traces for DCBX configuration
exchanges.
•
fail
: enables traces for DCBX failures.
•
mgmt
: enables traces for DCBX management frames.
•
resource
: enables traces for DCBX system resource
frames.
•
sem
: enables traces for the DCBX state machine.
•
tlv
: enables traces for DCBX TLVs.
Defaults none
627