Dell Force10 S4810P, Справочное руководство

Страница: 1364 / 1637

neighbor
Define a neighbor router with which to exchange RIP information.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax neighbor ip-address
To delete a neighbor setting, use the
no neighbor ip-address
command.
Parameters
ip-address Enter the IP address, in dotted decimal format, of a router with which
to exchange information.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1 Introduced on the E-Series.
Usage
Information
When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers
are possible.
Use the
passive-interface
command in conjunction with the
neighbor
command to
ensure that only specific interfaces are receiving and sending data.
Related
Commands passive-interface – sets the interface to only listen to RIP broadcasts.
network
Enable RIP for a specified network. Use this command to enable RIP on all networks connected to the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax network ip-address
To disable RIP for a network, use the
no network ip-address
command.
Parameters
ip-address
Specify an IP network address in dotted decimal format. You cannot
specify a subnet.
1364