Dell Force10 S4810P, Справочное руководство

Страница: 1579 / 1637

Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.4.2.3 Introduced on the S-Series S50.
Example
FTOS(conf-uplink-state-group-16)# description test
FTOS(conf-uplink-state-group-16)#
Related
Commands uplink-state-group – creates an uplink-state group and enables the tracking of upstream links.
downstream
Assign a port or port-channel to the uplink-state group as a downstream interface.
S-Series (S50 only), S4810
Syntax downstream interface
To delete an uplink-state group, enter the
no downstream interface
command.
Parameters
interface
Enter one of the following interface types:
• Fast Ethernet:
fastethernet { slot/port | slot/
port-range }
• 1-Gigabit Ethernet:
gigabitethernet { slot/port |
slot/port-range }
• 10-Gigabit Ethernet:
tengigabitethernet { slot/
port | slot/port-range }
• Port channel:
port-channel { 1-512 | port-
channel-range }
Where
port-range
and
port-channel-range
specify a
range of ports separated by a dash (-) and/or individual ports/port
channels in any order; for example:
gigabitethernet
1/1-2,5,9,11-12 port-channel 1-3,5
. A comma is
required to separate each port and port-range entry.
Defaults none
Command Modes UPLINK-STATE-GROUP
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.4.2.3 Introduced on the S-Series S50.
Usage
Information
You can assign physical port or port-channel interfaces to an uplink-state group.
You can assign an interface to only one uplink-state group. You must configure each interface
assigned to an uplink-state group as either an upstream or downstream interface, but not both.
1579