Dell Force10 S4810P, Справочное руководство

Страница: 446 / 1637

Command History
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
CAUTION: Dell Force10 recommends not changing the administrative distance of internal
routes. Changing the administrative distances may cause routing table inconsistencies.
The higher the administrative distance assigned to a route means that your confidence in that
route is low. Routes assigned an administrative distance of 255 are not installed in the routing
table. Routes from confederations are treated as internal BGP routes.
Related
Commands
router bgp – enters ROUTER mode on the switch.
neighbor activate
This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI.
C-Series, E-Series TeraScale, S-Series
Syntax neighbor [ ip-address | peer-group-name ] activate
To disable, use the
no neighbor [ ip-address | peer-group-name ]
activate
command.
Parameters
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name
(OPTIONAL) Enter the name of the peer group.
activate Enter the keyword
activate
to enable the neighbor/peer group in
the new AFI/SAFI.
Defaults Disabled
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information By default, when you create a neighbor/peer group configuration in the Router BGP context,
this enables IPv4/Unicast AFI/SAFI. By using
activate
in the new context, the neighbor/peer
group enables for AFI/SAFI.
Related
Commands address family ipv4 multicast (MBGP) – changes the context to SAFI.
446