Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 755 / 796

Operating Manual 1164.4556.12 - 06 7.21
R&S FSP Remote Control – Programming Examples
More Complex Programming Examples
During the measurement, each pulse is mapped into a pixel of the screen, i.e. any
change of the trace can be detected only at the left-hand edge of the screen. Maxi-
mum measurement speed is as usual achieved with the display switched off.
In the example below, a GSM pulse sequence of 8 pulses is measured with 5
µ
s
trigger offset, 434
µ
s measurement time/pulse, video trigger with 50% trigger thresh-
old, and peak detection:
REM ************************************************************************
Public Sub MultiBurstPower()
result$ = Space$(200)
'--------- R&S FSP default setting -------------------------
CALL SetupStatusReg
'Configure status register
status = viWrite(analyzer, "*RST", 4, retCnt)
'Reset instrument
status = viWrite(analyzer, "INIT:CONT OFF", 13, retCnt)
'Single sweep mode
status = viWrite(analyzer, "SYST:DISP:UPD OFF", 17, retCnt)
'OFF: display off
'--------- Perform measurement and query results ------------
cmd$ = "MPOW? "
cmd$ = cmd$ + "935.2 MHZ,"
'Center frequency
cmd$ = cmd$ + "1MHZ,"
'Resolution bandwidth
cmd$ = cmd$ + "434US,"
'Measurement time
cmd$ = cmd$ + "VID,"
'Trigger source
cmd$ = cmd$ + "50PCT,"
'Trigger threshold
cmd$ = cmd$ + "1US,"
'Trigger offset, must be > 125 ns
cmd$ = cmd$ + "PEAK,"
'Peak detector
cmd$ = cmd$ + "8"
'Number of bursts
status = viWrite(analyzer, cmd$, 47, retCnt)
status = viRead(analyzer, result$, 100, retCnt)
'Read results
Print result$
END SUB
REM ************************************************************************