Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 459 / 796

Operating Manual 1164.4556.12 - 06 6.65
R&S FSP Remote Control – Description of Commands
CALCulate Subsystem
Example:
"CALC:MARK:FUNC:TOI ON"
'Switches on the measurement of the third-order intercept in screen A.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
CALCulate<1|2>:MARKer<1...4>:FUNCtion:ZOOM <numeric_value>
This command defines the range to be zoomed around marker 1 in the selected measurement window.
Marker 1 is activated first, if necessary.
The subsequent frequency sweep is stopped at the marker position and the frequency of the signal is
counted. This frequency becomes the new center frequency, and the zoomed span is set. In order to
recognize the end of the operation the synchronization to the sweep end should be activated. This is
only possible in single-sweep mode.
Example:
"INIT:CONT OFF"
'Switches to single-sweep mode
"CALC:MARK:FUNC:ZOOM 1kHz;*WAI"
'Activates zooming in screen A and waits for its end.
for phase noise mode
"CALC1:MARK1:FUNC:ZOOM 10"
'Zooms in around marker 1 by a factor of 10.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.