Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 536 / 796

R&S FSP Remote Control – Description of Commands
OUTPut Subsystem
6.142 Operating Manual 1164.4556.12 - 06
6.15 OUTPut Subsystem
The OUTPut subsystem controls the output features of the instrument.
In conjunction with the tracking generator option, a distinction is made between OUTPut1 (screen A) and
OUTPut2 (screen B).
OUTPut<1|2>[:STATe] ON | OFF
This command switches the tracking generator on or off.
Example:
"OUTP ON"
'Switches on the tracking generator in screen A.
Characteristics: *RST value: OFF
SCPI: conform
Mode: A
This command is only valid in conjunction with option tracking generator R&S FSP-B9.
• With the tracking generator switched on, the maximum stop frequency is limited
to 3 GHz. This upper limit is automatically modified by the set frequency offset
of the generator.
• If measurements in compliance with specs are to be performed with the tracking
generator, the start frequency has to be
≥
3 x resolution bandwidth.
• The minimum sweep time for measurements in compliance with the data sheet
is 100 ms in the frequency domain (span >0). If a shorter sweep time is
selected, the sweep time indicator SWT on the screen is marked with a red
asterisk and the message UNCAL is also displayed.
• With the tracking generator switched on, the FFT filters (BAND:MODE:FFT) are
not available.