Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 475 / 796

Operating Manual 1164.4556.12 - 06 6.81
R&S FSP Remote Control – Description of Commands
CALCulate Subsystem
Example:
"INIT:CONT OFF"
'Switches to single-sweep mode.
"CALC:MARK:FUNC:SUMM:MEAN ON"
'Switches on the function in screen A.
"CALC:MARK:FUNC:SUMM:AVER ON"
'Switches on the average value calculation in screen A.
"INIT;*WAI"
'Starts a sweep and waits for the end.
"CALC:MARK:FUNC:SUMM:MEAN:AVER:RES?"
'Outputs the result of screen A.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A-T
This command is only a query and therefore has no *RST value.
CALCulate<1|2>:MARKer<1...4>:FUNCtion:SUMMary:MEAN:PHOLd:RESult?
This command queries the result of the measurement of the mean value with active peak hold in the
selected measurement window. The query is only possible if the peak hold function has been switched
on previously using
CALCulate<1|2>:MARKer<1...4>:FUNCtion:SUMMary:AVERage
The query is possible only if the peak hold function is active. The function is independent of the marker
selection, i.e. the numeric suffix <1...4> of
:MARKer
is irrelevant. It is only available in the time domain
(span = 0).
A complete sweep with synchronization to sweep end must be performed between switching on the
function and querying the measured value to obtain a valid query result. This is only possible in single-
sweep mode.
Example:
"INIT:CONT OFF"
'Switches to single-sweep mode
"CALC:MARK:FUNC:SUMM:MEAN ON"
'Switches on the function in screen A
"CALC:MARK:FUNC:SUMM:PHOL ON"
'Switches on the peak value measurement in screen A
"INIT;*WAI"
'Starts a sweep and waits for the end
"CALC:MARK:FUNC:SUMM:MEAN:PHOL:RES?"
'Outputs the result of screen A.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A-T
This command is only a query and therefore has no *RST value.