Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 387 / 796

Operating Manual 1164.4556.12 - 06 5.25
R&S FSP Remote Control – Basics
Status Reporting System
5.7.3.6 STATus:QUEStionable:ACPLimit Register
This register comprises information about the observance of limits during adjacent
power measurements. It can be queried with commands
STATus:QUEStionable:
ACPLimit:CONDition?
and
STATus:QUEStionable:ACPLimit[:EVENt]?
.
10 LMARgin
This bit is set if a margin is violated (see also section “STATus:QUEStionable:LMARgin<1|2>
Register” on page 5.28 )
11 This bit is not used
12 ACPLimit
This bit is set if a limit for the adjacent channel power measurement is violated (see also
section
“STATus:QUEStionable:ACPLimit Register” on page 5.25 )
13 to
14 These bits are not used
15 This bit is always 0.
Bit
No. Meaning
Bit
No. Meaning
0 ADJ UPPer FAIL(Screen A)
This bit is set if in screen A. the limit is exceeded in the upper adjacent channel
1 ADJ LOWer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the lower adjacent channel.
2 ALT1 UPPer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the upper 1st alternate channel.
3 ALT1 LOWer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the lower 1st alternate channel.
4 ALT2 UPPer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the upper 2nd alternate channel.
5 ALT2 LOWer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the lower 2nd alternate channel.
6 ALT3 to 11 LOWer/UPPer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in one of the lower or upper alternate channels
3 to 11.
7 not used
8 ADJ UPPer FAIL (Screen B)
This bit is set if in screen B the limit is exceeded in the upper adjacent channel.
9 ADJ LOWer FAIL (Screen B)
This bit is set if in screen B the limit is exceeded in the lower adjacent channel.
10 ALT1 UPPer FAIL (Screen B)
This bit is set if in screen B the limit is exceeded in the upper 1st alternate channel.
11 ALT1 LOWer FAIL (Screen B)
This bit is set if in screen B the limit is exceeded in the lower 1st alternate channel.