Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 548 / 796

R&S FSP Remote Control – Description of Commands
SENSe Subsystem
6.154 Operating Manual 1164.4556.12 - 06
[SENSe<1|2>:]CORRection:TRANsducer:CATalog?
This command queries all the names of the transducer files saved on the hard disc.
The syntax of the output is:
<sum of file length of all following files>,<free spaces on hard disc>,<1
st file name>,<1 st file length>,
<2 nd file name>,<2 nd file length>,....,<n th file name>,<n th file length>
Example:
"CORR:TRAN:CAT?"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
[SENSe<1|2>:]CORRection:TRANsducer:COMMent <string>
This command defines the comment for the selected transducer factor. Prior to this command, the
command
SENS:CORR:TRAN:SEL
must be sent.
Example:
"CORR:TRAN:SEL 'FACTOR1'"
"CORR:TRAN:COMM 'FACTOR FOR ANTENNA'"
Characteristics: *RST value: '' (empty comment)
SCPI: device-specific
Mode: A
This command is available from firmware version 1.40 or higher.
[SENSe<1|2>:]CORRection:TRANsducer:DATA <freq>,<level>..
This command defines the reference values of the transducer factor selected. These values are
entered as a sequence of frequency/level pairs. The frequencies must be sent in ascending order. Prior
to this command, the command
SENS:CORR:TRAN:SEL
must be sent. The level values are sent as
dimensionless numbers; the unit is specified by means of the command
SENS:CORR:TRAN:UNIT.
Example:
"CORR:TRAN:SEL 'FACTOR1'"
"CORR:TRAN:TRANsducer:DATA 1MHZ,-30,2MHZ,-40"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is available from firmware version 1.40 or higher.
[SENSe<1|2>:]CORRection:TRANsducer:DELete
This command deletes the selected transducer factor. Prior to this command, the command
SENS:
CORR:TRAN:SEL
must be sent.
Example:
"CORR:TRAN:SEL 'FACTOR1'"
"CORR:TRAN:DEL"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is available from firmware version 1.40 or higher.