Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 467 / 796

Operating Manual 1164.4556.12 - 06 6.73
R&S FSP Remote Control – Description of Commands
CALCulate Subsystem
MCACpower: Channel/adjacent channel power measurement with several carrier signals
Results are output in the following sequence, separated by commas:
1. Power of carrier signal 1
2. Power of carrier signal 2
3. Power of carrier signal 3
4. Power of carrier signal 4
5. Power of carrier signal 5
6. Power of carrier signal 6
7. Power of carrier signal 7
8. Power of carrier signal 8
9. Power of carrier signal 9
10.Power of carrier signal 10
11.Power of carrier signal 11
12.Power of carrier signal 12
13.Total power of all carrier signals
14.Power of lower adjacent channel
15.Power of upper adjacent channel
16.Power of lower alternate channel 1
17.Power of upper alternate channel 1
18.Power of lower alternate channel 2
19.Power of upper alternate channel 2
The number of measured values returned depends on the number of
carrier signals and adjacent/alternate channels selected with
SENSe:POWer:ACHannel:TXCHannel:COUNt
and
SENSe:POWer:ACHan-
nel:ACPairs
.
If only one carrier signal is measured, the total value of all carrier signals will not
be output.
With logarithmic scaling (RANGE LOG), the power is output in dBm; with linear
scaling (RANGE LIN dB or LIN %), the power is output in W. If
SENSe:POWer:
ACHannel:MODE REL
is selected, the adjacent/alternate-channel power is out-
put in dB.
OBANdwidth |
OBWidth: Measurement of occupied bandwidth
The occupied bandwidth in Hz is returned.
CN: Measurement of carrier-to-noise ratio
The carrier-to-noise ratio in dB is returned.
CN0: Measurement of carrier-to-noise ratio referenced to 1 Hz bandwidth.
The carrier-to-noise ratio in dB/Hz is returned.