Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 598 / 796

R&S FSP Remote Control – Description of Commands
SENSe Subsystem
6.204 Operating Manual 1164.4556.12 - 06
Mode: A
[SENSe<1|2>:]SWEep:EGATe:TRACe<1..3>STARt<1..3> | STOP<1..3> <value>
Sets the start or stop value of a gate range in the gate range table.
The suffix after TRACe indicates the trace.
The suffix after STARt | STOP indicates the range.
Example:
"SWE:EGAT:TRAC1:STAR2 5us"
’Start value of range 2, trace 1 is set to 5
µ
s.
Characteristics: *RST value: 1.797308
SCPI: device-specific
Mode: A
[SENSe<1|2>:]SWEep:EGATe:TRACe<1..3>STATe<1..3> ON | OFF
The gate range in the gate range table is set on or off.
The suffix after TRACe indicates the trace.
The suffix after STATe indicates the range.
Example:
"SWE:EGAT:TRAC2:STAT1 ON"
’Range 1 for trace 2 is switched on.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
[SENSe<1|2>:]SWEep:EGATe:TYPE LEVel | EDGE
This command sets the type of triggering (level or edge) by the external gate signal.
The gate opening time cannot be defined with the parameter
EGATe:LENGth
in case of level
triggering. The gate is closed when the gate signal disappears.
Example:
"SWE:EGAT:TYPE EDGE"
Characteristics: *RST value: EDGE
SCPI: device-specific
Mode: A
[SENSe<1|2>:]SWEep:MODE AUTO | LIST | ESPectrum
This command controls the sweep continuation.
Example:
"SWE:MODE LIST"
Activates the spurious emissions measurement.
AUTO free running sweep - the spurious list is activated
ESPectrum activates the Spectrum Emission Mask measurement
LIST Activates the spurious emissions measurement. The sweep list is
defined using the SENS:LIST:RANGE commands.