Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 504 / 796

R&S FSP Remote Control – Description of Commands
DISPlay Subsystem
6.110 Operating Manual 1164.4556.12 - 06
DISPlay[:WINDow<1|2>]:TEXT[:DATA] <string>
This command defines a comment (max. 20 characters) which can be displayed on the screen in the
selected measurement window.
Example:
"DISP:WIND2:TEXT 'Noise Measurement'"
'Defines the title for screen B
Characteristics: *RST value: "" (empty)
SCPI: conform
Mode: A
DISPlay[:WINDow<1|2>]:TEXT:STATe ON | OFF
This command switches on or off the display of the comment (screen title) in the selected
measurement window.
Example:
"DISP:TEXT:STAT ON"
'Switches on the title of screen B.
Characteristics: *RST value: OFF
SCPI: conform
Mode: A
DISPlay[:WINDow<1|2>]:TIME ON | OFF
This command switches on or off the screen display of date and time. The numeric suffix in
WINDow<1| 2> is irrelevant.
Example:
"DISP:TIME ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
DISPlay[:WINDow<1|2>]:TRACe<1...3>:MODE WRITe | VIEW | AVERage | MAXHold | MINHold
This command defines the type of display and the evaluation of the traces in the selected
measurement window. WRITE corresponds to the Clr/Write mode of manual operation.
The trace is switched off (= BLANK in manual operation) with the DISPlay[:WINDow<1|2>]:
TRACe<1...3>[:STATe] command.
The number of measurements for AVERage, MAXHold and MINHold is defined with the [SENSe<1|2>:
]AVERage:COUNt or [SENSe<1|2>:]SWEep:COUNt command.
Synchronization to the end of the indicated number of measurements is only possible in single-sweep
mode.
If calculation of average values is active, selection between logarithmic and linear averaging is
possible. For more detail see command
[SENSe<1|2>:]AVERage:TYPE .