Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 595 / 796

Operating Manual 1164.4556.12 - 06 6.201
R&S FSP Remote Control – Description of Commands
SENSe Subsystem
6.16.12 SENSe:SWEep Subsystem
This subsystem controls the sweep parameters.
The measurement windows are selected by SENSe1 (screen A) and SENSe2 (screen B).
[SENSe<1|2>:]SWEep:COUNt 0 to 32767
This command defines the number of sweeps started with single sweep, which are used for calculating
the average or maximum value. In average mode, the value 0 defines a continuous averaging of
measurement data over 10 sweeps.
Example:
"SWE:COUN 64"
'Sets the number of sweeps to 64.
"INIT:CONT OFF"
'Switches to single-sweep mode.
"INIT;*WAI"
'Starts a sweep and waits for its end.
Characteristics: *RST value: 0
SCPI: conform
Mode: A
[SENSe<1|2>:]SWEep:COUNt:CURRent?
This query command returns the current number of started sweeps. A sweep count value should be
set and the device should be in single-sweep mode. This command is a query and therefore has no
*RST value.
Example:
"SWE:COUNt 64"
'sets sweep count to 64
"INIT:CONT OFF"
'switches to single-sweep mode
"INIT"
'starts a sweep (without waiting for the sweep end!)
"SWE:COUN:CURR?"
'queries the number of started sweeps
Characteristics: *RST value: --
SCPI: conform
Mode: A