Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 233 / 796

Operating Manual 1164.4556.12 - 06 4.161
R&S FSP Instrument Functions
Basic Settings
DEFAULT
COLORS 1/
DEFAULT
COLORS 2
The DEFAULT COLORS 1/2 softkeys restores the default settings for brightness,
color tint and color saturation for all display screen elements.
The color schemes have been selected to give optimum visibility of all picture ele-
ments at an angle of vision from above or below.
DEFAULT COLORS 1 is active in
the default setting of the instrument.
Remote command:
DISP:CMAP:DEF1
DISP:CMAP:DEF2
DISPLAY PWR
SAVE
The DISPLAY PWR SAVE softkey is used to switch on/off the power-save mode for
the display and to enter the time for the power-save function to respond. After the
elapse of this time the display is completely switched off, i.e. including backlighting.
The power-save mode is configured as follows:
• The first keystroke activates the power-save mode and opens the editor for the
response time. The response time is entered in minutes between 1 and 6 minutes
and is confirmed by
ENTER .
• The power-save mode is deactivated by pressing the key again.
On leaving the menu with the power-save mode in the activated state, the softkey is
highlighted in color on returning to the menu and opens again the editor for the
response time. Pressing again the key switches off the power-save mode.
Remote command:
DISP:PSAV ON
DISP:PSAV:HOLD 15
SELECT
OBJECT
The SELECT OBJECT softkey activates the SELECT DISPLAY OBJECT table, with
which a graphics element can be selected. After selection, the brightness, tint and
saturation of the selected element can be changed using the softkeys of the same
name. The color changes by means of the
PREDEFINED COLORS softkey can be
seen immediately on the display screen.
This mode is recommended for saving the TFT display especially when the instru-
ment is exclusively operated in remote control.