Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 549 / 796

Operating Manual 1164.4556.12 - 06 6.155
R&S FSP Remote Control – Description of Commands
SENSe Subsystem
This command is an event and therefore has no *RST value.
[SENSe<1|2>:]CORRection:TRANsducer:GENerate <name>
This command generates a transducer factor <name> using normalized trace data. The function is
only available when normalization is switched on.
Parameter: <name>::= Name of the transducer factors as string data with up to 8 characters.
Example:
"CORR:TRAN:GEN 'FACTOR1'"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
[SENSe<1|2>:]CORRection:TRANsducer:SCALing LINear | LOGarithmic
This command defines whether the frequency scaling of the transducer factor is linear or logarithmic.
Prior to this command, the command
SENS:CORR:TRAN:SEL
must be sent.
Example:
"CORR:TRAN:SEL 'FACTOR1'"
"CORR:TRAN:SCAL LOG"
Characteristics: *RST value: LINear
SCPI: device-specific
Mode: A
This command is available from firmware version 1.40 or higher.
[SENSe<1|2>:]CORRection:TRANsducer:SELect <name>
This command selects the transducer factor designated by <name>. If <name> does not exist yet, a
new transducer factor is created.
Parameter: <name>::= Name of the transducer factor in string data form with a maximum of 8
characters.
Example:
"CORR:TRAN:SEL 'FACTOR1'"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is available from firmware version 1.40 or higher.
This command must be sent prior to the subsequent commands for modifying/acti-
vating transducer factors.