Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 597 / 796

Operating Manual 1164.4556.12 - 06 6.203
R&S FSP Remote Control – Description of Commands
SENSe Subsystem
[SENSe<1|2>:]SWEep:EGATe:LENGth 0 to 100 s
In case of edge triggering, this command determines the time interval during which the instrument
sweeps.
Example:
"SWE:EGAT:LENG 10ms"
Characteristics: *RST value: 0s
SCPI: device-specific
Mode: A
[SENSe<1|2>:]SWEep:EGATe:POLarity POSitive | NEGative
This command determines the polarity of the external gate signal. The setting is valid both for the edge
of an edge-triggered signal and the level of a level-triggered signal.
Example:
"SWE:EGAT:POL POS"
Characteristics: *RST value: POSitive
SCPI: device-specific
Mode: A
[SENSe<1|2>:]SWEep:EGATe:SOURce EXTernal | IFPower | RFPower
This command toggles between external gate signal and IF power/RF power signal as a signal source
for the gate mode. If an IF power signal is used, the gate is opened as soon as a signal at > -20 dBm
is detected within the IF path bandwidth (10 MHz).
Example:
"SWE:EGAT:SOUR IFP"
'Switches the gate source to IF power.
Characteristics: *RST value: IFPower
SCPI: device-specific
Mode: A
[SENSe<1|2>:]SWEep:EGATe:TRACe<1..3>COMMent
To enter a comment string in the gate range table.
The suffix after TRACe indicates the trace.
Example:
"SWE:EGAT:TRAC2:COMMent"
’To enter a comment in trace 2.
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
[SENSe<1|2>:]SWEep:EGATe:TRACe<1..3>PERiod <value>
The period of the signal is set for the gate range table.
The suffix after TRACe indicates the trace.
Example:
"SWE:EGAT:TRAC1:PER 5ms"
’Period of trace 1 is set to 5 ms.
Characteristics: *RST value: 1.797308
SCPI: device-specific