Mitsubishi Electric GOT2000 Series, Connection Manual

Page: 352 / 1224

5 - 86
5.4 PLC Side Setting
■3.
Ethernet parameter settings of FX3U-ENET-ADP
(1) Ethernet settings
Set the Ethernet parameter at [FX Parameter] on GX Works2.
To set FX3U-ENET-ADP, GX Works2 Ver.1.90U or later is required.
For details on the setting of FX3U-ENET-ADP, refer to the following manual.
➠
FX3U-ENET-ADP User's Manual
:Required :Set if necessary :Not required
*1 Set a channel according to the installation position of FX3U-ENET-ADP on the CPU body.
*2 The default value of IP address is 192.168.1.250. Set the IP address corresponding to the system configuration.
POINT POINT POINT
When changing Ethernet parameter
After writing Ethernet parameters to the PLC CPU, turn the PLC CPU OFF then back ON again.
(2) Open settings
Item Setting
Setting
(with GOT connected)
Channel
CH1 or CH2
*1
IP Address
192.168.3.19
*2
Open Settings Refer to (2).
Communication Data Code
(Use default value.) Disable direct connection to MELSOFT
Do not respond to search for CPU on network
Item Setting
Setting
(with GOT connected)
Protocol TCP
Open System MELSOFT connection