Mitsubishi Electric GOT2000 Series, Connection Manual

Page: 345 / 1224

5.4 PLC Side Setting
5 - 79
5
E
T
H
E
RNET CONNEC
T
ION
(2) Exchange condition setting switch
*1
: Necessary : As necessary : Not necessary
*1 The exchange condition setting switches of A1SJ71E71-B5-S3 and A1SJ71E71-B2-S3 are specified as the below.
: Necessary : As necessary : Not necessary
POINT POINT POINT
When the switch setting has been changed
Turn the PLC CPU OFF then ON again, or reset the PLC CPU.
■3.
Sequence program
The sequence program for initial processing and communication line opening processing are required.
(1) Programming condition
This program performs the initial processing of the Ethernet module and the opening processing of connection No. 1
when the stopping PLC CPU starts running.
(a) I/O signal of Ethernet module
➠ For A Ethernet Interface Module User’s Manual
(b) Device used by user
Exchange condition setting
switch
Setting
switch
Description Set value
Setting necessity at GOT
connection
SW1
Selection of line processing at TCP
timeout error
OFF
SW2
Data code setting
(binary code) OFF
(fixed)
SW3
(Must not to be used)
OFF
(fixed)
SW4
SW5
SW6
SW7
CPU exchange timing setting
(Enable write at RUN time) ON
(fixed)
SW8 Initial timing setting OFF
Exchange condition
setting switch
Setting
switch
Description Set value
Setting necessity at
GOT connection
SW1
Selection of line processing at
TCP timeout error
OFF
SW2
Data code setting
(binary code) OFF
(fixed)
SW3
CPU exchange timing setting
(Enable write at RUN time) ON
(fixed)
SW4 Initial timing setting OFF
Device Application
M102 COM.ERR turned off command
D100 IP address of Ethernet module
D110 Application setting
D111 Port No. of Ethernet module
D112 to D113 IP address of GOT
D114 Port No. of GOT
D200 Initial fault code
SW1
SW2
SW3
SW4
SW5
SW6
SW7
SW8
OFF ON
SW1
SW2
SW3
SW4
OFF ON