Mitsubishi Electric GOT2000 Series, Connection Manual

Page: 337 / 1224

5.4 PLC Side Setting
5 - 71
5
E
T
H
E
RNET CONNEC
T
ION
(2) Q24DHCCPU-V/VG/LS
Use SW4PVC-CCPU-E for the C Controller (Q Series) setting utility.
(a) Connection settings
: Necessary : As necessary : Not necessary
*1 If the IP address of the C Controller module (Q Series) has been changed, input the changed IP address.
■3.
[Controller Setting] and [Ethernet] of GT Designer3
POINT POINT POINT
(1) [Controller Setting] and [Ethernet] of GT Designer3
For [Controller Setting] and [Ethernet] of GT Designer3, refer to the following.
➠ 5.3.1 Setting communication interface (Controller Setting)
(2) Ethernet setting
When connecting C Controller module (Q Series) to a GOT, the setting items for the network
No. and station No. do not exist at the PLC side. However, these virtual values must be set
on the GOT side. Therefore, set the network No. and station No.
Set the network No. that is not existed on the network system and any station No..
(1) Controller setting
Item Set value
Setting necessity at GOT
connection
IP Address
*1
192.168.3.39
(Default)
Subnet Mask
255.255.255.0
(Default)
Default Gateway -
Item Set value (Use default value)
GOT Net No. 1
GOT Station 1
GOT Standard Ethernet Setting 192.168.3.18
GOT Communication Port No. 5001
Retry 3times
Startup Time 3sec
Timeout Time 3sec
Delay Time 0ms