Mitsubishi Electric GOT2000 Series, Connection Manual

Page: 322 / 1224

5 - 56
5.4 PLC Side Setting
(2) [Controller Setting] and [Ethernet] of GT Designer3
POINT POINT POINT
(1) [Controller Setting] and [Ethernet] of GT Designer3
For [Controller Setting] and [Ethernet] of GT Designer3, refer to the following.
➠
5.3.1Setting communication interface (Controller Setting)
(2) Ethernet setting
When connecting Built-in Ethernet port CPU to a GOT, the settings items for the network No.
and station No. do not exist at the PLC side. However, these virtual values must be set on the
GOT side.
Therefore, set the network No. and station No. Set the network No. that is not existed on the
network system and any station No..
(a) Controller setting
(b) GOT Standard Ethernet Setting
(c) Ethernet setting
*1 Set the same value as that of GOT N/W No.
*2 Set a value different from that of the GOT PLC No.
Item Set value (Use default value)
GOT Net No. 1
GOT Station 1
GOT Standard Ethernet Setting 192.168.3.18
GOT Communication Port No. 5001
Retry 3 times
Startup Time 3 sec
Timeout Time 3 sec
Delay Time 0ms
Item Set value (Use default value)
GOT IP Address 192.168.3.18
Subnet Mask 255.255.255.0
Default Gateway 0.0.0.0
Peripheral Communication Port No. 5015
Transparent Port No. 5014
Item Set value
Ethernet setting No.1
Host *
N/W No.
1
*1
PLC No.
2
*2
Type QnUD(P)V/QnUDEH
IP address 192.168.3.39
Port No. 5001
Communication UDP (fixed)