Mitsubishi Electric GOT2000 Series, Connection Manual

Page: 60 / 1224

1 - 30
1.4 Connection Cables for the Respective Connection
1.4.2 Coaxial cableconnector connection method
The following describes the method for connecting the BNC connector (connector plug for coaxial cable) and the cable.
Step 1.
Remove the external sheath of the coaxial cable with dimensions as shown below.
Step 2.
Pass the nut, washer, gasket, and clamp through the coaxial cable as shown on the left and loosen the
external conductor.
Step 3.
Cut the external conductor, insulting material, and internal conductor with the dimensions as shown below.
Note that the external conductor should be cut to the same dimension as the tapered section of the clamp
and smoothed down to the clamp.
Step 4.
Solder the contact to the internal conductor.
Cable in use B C
3C-2V 6 mm 3 mm
5C-2V, 5C-2V-CCY 7 mm 5 mm
CAUTION

Solder the coaxial cable connectors properly.
Insufficient soldering may result in malfunctions.
Nut Washer Gasket
Clamp Contact
Components of the BNC connector
Plug shell
Outer sheath
External conductor
Insulating material
Internal conductor
Structure of the coaxial cable
A
Cut this portion of the outer sheath
Clamp
Gasket
Washer
Nut
Internal conductor
Insulating material
C
B
Clamp and external
conductor
Solder here