Mitsubishi Electric GOT2000 Series, Connection Manual

Page: 656 / 1224

12 - 14
12.3 GOT Side Settings
For details of the hardware test, refer to the following manual.
➠
CC-Link System Master/Local Module User's Manual for CC-Link module to be used
*2 In the case of MELSEC iQ-F series or MELSEC-FX, Transmission method is set to "cyclic".
POINT POINT POINT
(1) Communication interface setting by Utility
The communication interface setting can be changed on the Utility's [Communication
Settings] after writing [Controller Setting] of project data.
For details on the Utility, refer to the following manual.
➠
GOT2000 Series User's Manual (Utility)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
(3) Indirect specification of the servo axis No.
When the servo axis No. is specified to 100 to 115 in GT Designer3, the servo axis number
can be indirectly specified using the 16-bit GOT internal data register (GD device).
Set the head No. of the GOT internal data register (GD device) to be used when indirectly
specifying as “Servo axis switching GD device head No.”
When the set value of “Servo axis switching GD device head No.” is “10”, the values of GD10
to GD25 are servo axis numbers. For details, refer to the following table.
D Hardware test: 5Mbps
E Hardware test: 10Mbps
Specified servo
axis number
Compatible device Setting range
100 GD10
1 to 64
For the setting other than the above, error (dedicated device
is out of range) will occur.
101 GD11
102 GD12
103 GD13
104 GD14
105 GD15
106 GD16
107 GD17
108 GD18
109 GD19
110 GD20
111 GD21
112 GD22
113 GD23
114 GD24
115 GD25
Set value Description