Mitsubishi Electric GOT2000 Series, Connection Manual

Page: 312 / 1224

5 - 46
5.4 PLC Side Setting
: Necessary : As necessary : Not necessary
*1 Set the IP address corresponding to the CH No. to be used to connect to the GOT.
■3.
[Controller Setting] and [Ethernet] of GT Designer3
POINT POINT POINT
(1) [Controller Setting] and [Ethernet] of GT Designer3
For [Controller Setting] and [Ethernet] of GT Designer3, refer to the following.
➠
5.3.1 Setting communication interface (Controller Setting)
(2) Ethernet setting
When connecting Built-in Ethernet port CPU to a GOT, the setting items for the network No.
and station No. do not exist at the PLC side. However, these virtual values must be set on the
GOT side. Therefore, set the network No. and station No.
Set the network No. that does not exist on the network system and any station No.
(1) Controller setting
(2) GOT Standard Ethernet Setting
IP Address -
Subnet Mask -
Default Gateway -
External Device Configuration -
Item Set value (Use default value)
GOT NET No. 1
GOT Station 1
GOT Standard Ethernet Setting 192.168.3.18
GOT Communication Port No. 5001
Retry 3times
Startup Time 3sec
Timeout Time 3sec
Delay Time 0ms
Item Set value (Use default value)
GOT IP Address 192.168.3.18
Subnet Mask 255.255.255.0
Default Gateway 0.0.0.0
Peripheral Communication Port No. 5015
Transparent Port No. 5014
Item
*1 Set value Setting necessity at GOT connection