Mitsubishi Electric GOT2000 Series, Connection Manual, Page: 747 / 1224

13.5 PLC Side Settings
13 - 21
CC
-Link CONNECTION (V
ia G4)
13
(2) Data link transmission speed setting switch
: Necessary : As necessary : Not necessary
(3) Mode setting switch
: Necessary : As necessary : Not necessary
(4) RS-232 transmission setting switch
: Necessary : As necessary : Not necessary
*1 The peripheral connection module operates with the baud rate set in the GOT.
➠
13.5.6 [Controller Setting] of GT Designer3
POINT POINT POINT
Precautions when setting peripheral connection module
(1) mode setting switch
Be sure to set the Operation mode setting switch to "5" (MELSOFT/connection mode).
(2) RS-232 transmission setting switch
Turn OFF SW1 through SW8 of the RS-232 transmission setting switch.
If any switch of SW1 through SW8 is ON, setting error will occur (RUN LED turns off).
Data link transmission speed setting switch Description Set value
Setting necessity at GOT
connection
Data link transmission speed
setting
0: 156kbps
1: 625kbps
2: 2.5Mbps
3: 5Mbps
4: 10Mbps
Mode setting switch Description Set value
Setting necessity at GOT
connection
Mode setting
5 (fixed)
(MELSOFT/
connection mode)
RS-232 transmission
setting switch
Setting
switch
Description Set value
Setting necessity at GOT
connection
SW1
Peripheral transmission
speed
*1
OFF
(fixed)
SW2
SW3
SW4
SW5 Data bit length
OFF
(fixed)
SW6
Parity bit length
OFF
(fixed)
SW7
SW8 Stop bit length
OFF
(fixed)