Mitsubishi Electric GOT2000 Series, Connection Manual

Page: 669 / 1224

12.4 PLC Side Setting
12 - 27
CC-Link
C
O
NN
ECTION (INTELLIGE
NT DEVICE ST
A
T
ION)
12
(b) Link refresh setting
: Necessary : As necessary : Not necessary
(c) CC-Link configuration setting
• CC-Link configuration setting of station No.1 (GOT)
: Necessary : As necessary : Not necessary
• CC-Link configuration setting of station No.2 (GOT)
: Necessary : As necessary : Not necessary
*1 When the [Mode] of the CC-Link module is set at [Remote net - (Ver. 2 mode)], [Remote station points] can be set.
[Remote station points] is a setting for the remote I/O station.
The default value (32 points) must be used on the GOT.
*2 Set the same setting as that of the GOT.
POINT POINT POINT
When changing the module parameter
After writing module parameters to the PLC CPU, turn the PLC CPU OFF then back ON again, or
reset the PLC CPU.
Item Set value
Setting necessity at GOT
connection
Remote input (RX) refresh device
Set as necessary. Remote output (RY) refresh device
Remote register (RWr) refresh device
Item
*1
Set value
Setting necessity at GOT
connection
Station type Ver.1 intelligent device station (fixed)
Exclusive station count
*2
Exclusive station 1
Reserve/invalid station select No setting
Intelligent buffer select (word) (Use default value)
Item
*1 Set value
Setting necessity at GOT
connection
Station type Ver.2 intelligent device station (fixed)
Expanded cyclic setting
*2
Single
Exclusive station count
*2
Exclusive station 1
Reserve/invalid station select No setting
Intelligent buffer select (word) (Use default value)