Mitsubishi Electric GOT2000 Series, Connection Manual

Page: 367 / 1224

5.4 PLC Side Setting
5 - 101
5
E
T
H
E
RNET CONNEC
T
ION
■3. [Controller Setting] and [Ethernet] of GT Designer3
POINT POINT POINT
(1) [Controller Setting] and [Ethernet] of GT Designer3
For [Controller Setting] and [Ethernet] of GT Designer3, refer to the following.
➠
5.3.1 Setting communication interface (Controller Setting)
(2) Ethernet setting
The settings items for the network No. and station No. do not exist at the Built-in Ethernet
port Motion Controller CPU side. However, these virtual values must be set on the GOT side.
Therefore, set the network No. and station No. on the GOT side. Set the network No. that is
not existed on the network system and any station No..
(1) Controller setting
(2) GOT Standard Ethernet Setting
(3) Ethernet setting
*1 Set the same value as that of GOT N/W No.
*2 Set a value different from that of GOT PLC No.
*3 Set it to the IP address value of the Built-in Ethernet port Motion Controller CPU side.
*4 The following [Port No.] and [Communication format] can also be set.
[Port No.]: 5007
[Communication]: TCP
Host station port No. -
Item Setting (Use default value.)
GOT Net No. 1
GOT Station 1
GOT Standard Ethernet Setting 192.168.3.18
GOT Communication Port No. 5001
Retry 3times
Startup Time 3 sec
Timeout Time 3 sec
Delay Time 0ms
Item Setting (Use default value.)
GOT IP Address 192.168.3.18
Subnet Mask 255.255.255.0
Default Gateway 0.0.0.0
Peripheral Communication Port No. 5015
Transparent Port No. 5014
Item Set value
Ethernet
setting No.1
Host *
N/W No.
1
*1
PC No.
2
*2
Type QnUD(P)V/QnUDEH
IP address
192.168.3.39
*3
Port No.
*4
5006
Communication
*4 UDP
Item Set value