Mitsubishi Electric GOT2000 Series, Connection Manual

Page: 681 / 1224

12.4 PLC Side Setting
12 - 39
CC-Link
C
O
NN
ECTION (INTELLIGE
NT DEVICE ST
A
T
ION)
12
(2) CC-Link Utility's [Parameter Settings]
(a) Parameter settings
: Necessary : As necessary : Not necessary
*1 When the [Mode] of the CC-Link module is set at [Remote net - (Ver. 2 mode)], [Remote station points] can be set.
[Remote station points] is a setting for the remote I/O station.
The default value (32 points) must be used on the GOT.
*2 Set the same setting as that of the GOT.
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the C Controller module (Q Series), either turn the C
Controller module (Q Series) OFF and then ON or reset it.
Item
*1
Set value
Setting necessity at GOT
connection
Number of modules 1
Target module 1
Start I/O No. 0000H
Channel No. (Use default value)
Operation
settings
Type Master station
Mode
Remote net
(Ver.2 mode)
Expanded cyclic setting Single
Occupied number Exclusive station 1
Error event: input data status Clear
CPU stop: data link status Refresh
Other settings (Use default value)
Station
information
settings
All connect count 1
Station Type Sta. No.1 Ver.2 intelligent device station
Expanded cyclic setting
*2
Sta. No.1 Single
Occupied number
*2
Sta. No.1 Exclusive station 1
Remote station points Sta. No.1 32 points
Reserve/invalid station select Sta. No.1 No setting
Intelligent buffer select (word) (Use default value)