Mitsubishi Electric GOT2000 Series, Connection Manual

Page: 700 / 1224

12 - 58
12.4 PLC Side Setting
(b) Station information setting
: Necessary : As necessary : Not necessary
*1 Specify the same number of occupied stations as that of the GOT.
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU, operate the PLC CPU ether turning OFF
and then ON or resetting.
(2) Setting from sequence program
The parameter is written to the buffer memory, and the data link is automatically started when PLC CPU status
changes from STOP to RUN.
(a) I/O signal of CC-Link module
➠
Control & Communication Link System Master/Local Module Type AJ61QBT11/A1SJ61QBT11
User's Manual
(b) Device used by user
Item Set value
Setting necessity at GOT
connection
Station type Intelligent device station (fixed)
Exclusive station count
*1
Exclusive station 1
Reserve/invalid station select No setting
Intelligent buffer select (word) (Use default value)
Device Application
M100, M101 Flag for parameter setting
M102, M103 Flag for data link startup
D0 Number of connected modules
D1 Number of retry
D2 Automatic reconnection station count
D3 Operation specification in the case of CPU failure
D4 Reserved station specification (Station No. 1 to Station No. 16)
D5 Error invalid station specification (Station No. 1 to Station No. 16)
D6 Station data (first module)
D400 Error code in the case of data link startup failure