PRELIMINARY
HSMMC CONTROLLER
S3C6400X RISC MICROPROCESSOR
27-4
Preliminary product information describe products that are in development,
for which full characterization data and associated errata are not yet available.
Specifications and information herein are subject to change without notice.
(3) Check Card Inserted in the Present State register. In this case where Card Inserted is 1, the Host Driver can
supply the power and the clock to the SD card. In this case where Card Inserted is 0, the other executing
processes of the Host Driver shall be immediately closed.
SD CLOCK SUPPLY SEQUENCE
START
Calculate a divisor for SD Clock frequency
Set SDCLK frequency select and
Internal Clock Enable
Check Internal Clock
Enable
Set SD Clock ON
End
(1)
(2)
(3)
(4)
Figure 27-3. SD Clock Supply Sequence
The sequence for supplying SD Clock to a SD card is described in Figure 27-3. The clock shall be supplied to the
card before one of the following actions is taken.
a) Issuing a SD command
b) Detect an interrupt from a SD card in 4-bit mode.
(1) Calculate a divisor to determine SD Clock frequency for SD Clock by reading Base Clock Frequency in the
Capabilities register. If Base Clock Frequency for SD Clock is 00 0000b, the Host System shall provide this
information to the Host Driver by another method.
(2) Set Internal Clock Enable and SDCLK Frequency Select in the Clock Control register in accordance with the
calculated result of step (1).
(3) Check Internal Clock Stable in the Clock Control register. Repeat this step until Clock Stable is 1.
(4) Set SD Clock Enable in the Clock Control register to 1. Then, the Host Controller starts to supply the SD
Clock.