Rohde & Schwarz 1311.6010.22, User Manual

Page: 967 / 1451

Command Reference
R&S
®
ZNB/ZNBT
967 User Manual 1173.9163.02 ─ 53
Parameters:
<BinValue> 0 - high
1 - low
*RST:
n/a (default: 0)
Example: CONT:HAND:OUTP2:DATA 0
Set the /OUTPUT2 line (pin 4) to 0 (current state of /
OUTPUT2).
CONT:HAND:OUTP2:USER 1
Define the next state of the /OUTPUT2 line as 1 (low). /
OUTPUT2 will go from 0 to 1 when the analyzer receives a neg-
ative pulse on the /INPUT1 line (pin 2).
CONTrol:HANDler:PASSfail:LOGic <Logic>
Specifies the the logic of the /PASS FAIL line (pin 33) of the Universal Interface.
Parameters:
<Logic> POSitive | NEGative
POSitive
–
high meas PASS, low means FAIL
NEGative
–
low meas PASS, high means FAIL
Note:
*RST
or "Preset" do not change the configuration of the
Universal Interface. Use
CONTrol:HANDler:RESet
to restore
default values.
*RST:
n/a (default: POSitive)
Example: See
CONTrol:HANDler:PASSfail:MODE
CONTrol:HANDler:PASSfail:MODE <Mode>
Specifies the default logical pass/fail state and the timing of the /PASS FAIL line (pin
33). The /PASS FAIL STROBE (pin 36) is set after the /PASS FAIL line; see
Chap-
ter 11.3.4.4, "Timing of Control Signals" , on page 1394.
If the mode is PASS or FAIL, the /PASS FAIL line is returned to its default state when
the analyzer is ready for a new measurement (/READY FOR TRIGGER).
Parameters:
<Mode> NOWait | PASS | FAIL
NOWait
–
the /PASS FAIL line is set as soon as a failure condi-
tion occurs.
PASS
–
the line stays in PASS state (as defined by
CONTrol:
HANDler:PASSfail:LOGic
) until a sweep end condition
(determined by
CONTrol:HANDler:PASSfail:SCOPe
)
occurs.
FAIL
–
the line stays in FAIL state until a sweep end condition
occurs.
Note:
*RST
or "Preset" do not change the configuration of the
Universal Interface. Use
CONTrol:HANDler:RESet
to restore
default values.
SCPI Command Reference