Rohde & Schwarz 1311.6010.22, User Manual

Page: 1199 / 1451

Command Reference
R&S
®
ZNB/ZNBT
1199 User Manual 1173.9163.02 ─ 53
[SENSe<Ch>:]SWEep:DWELl:IPOint <InsertionPoints>
Defines whether the measurement delay (previously defined via
[SENSe<Ch>:
]SWEep:DWELl
) is inserted before all partial measurements or before the first partial
measurement only.
Suffix:
<Ch>
.
Channel number
Parameters:
<InsertionPoints> ALL | FIRSt
Insertion before all or before the first partial measurement
*RST:
ALL
Example: See
[SENSe<Ch>:]SWEep:DWELl
Manual operation: See "All Partial Meas'ments / First Partial Meas'ment"
on page 396
[SENSe<Ch>:]SWEep:GENeration <arg0>
Sets/gets the sweep mode for linear frequency sweeps.
For segmented sweeps this can be overridden by segment-specific sweep modes
(
[SENSe<Ch>:]SEGMent<Seg>:SWEep:GENeration
).
Suffix:
<Ch>
.
Channel number
Parameters:
<arg0> STEPped | ANALog
Stepped mode or swept mode (=ANALog).
*RST:
STEPped
Manual operation: See "Freq Sweep Mode" on page 396
[SENSe<Ch>:]SWEep:GENeration:ANALog:CONDition?
Returns the state of the swept mode (see
[SENSe<Ch>:]SWEep:GENeration
and
[SENSe<Ch>:]SEGMent<Seg>:SWEep:GENeration
), which can be one of the fol-
lowing:
●
0, "Swept mode not active."
●
1, "Swept mode active."
(for at least one segment in segmented sweeps)
●
-1, "Swept mode not possible while external powermeter is used."
●
-2, "Swept mode not possible while external generator is used."
●
-3, "Swept mode not possible while Point or Partial Measurement Trigger is used."
●
-4, "Swept mode not possible while Point Delay is used."
●
-5, "Swept mode not possible while Chopped Driving Mode is used."
●
-6, "Swept mode not possible while DC Measurement is used."
SCPI Command Reference