Rohde & Schwarz 1311.6010.22, User Manual

Page: 384 / 1451

GUI Reference
R&S
®
ZNB/ZNBT
384 User Manual 1173.9163.02 ─ 53
Remote command:
CALCulate:MARKer:COUPled:TYPE
Reset Marker Coupling
Convenience function for disabling marker coupling and setting the Coupling Type to
"All" (default).
Remote command:
CALCulate:MARKer:COUPled[:STATe] OFF
CALCulate:MARKer:COUPled:TYPE ALL
6.8 Stimulus Softtool
On the "Stimulus" softtool, you can access to the stimulus parameters of the active
channel. If the active trace is represented in
Time Domain , it also allows you to config-
ure the "observation interval".
Access: STIMULUS – [START] | [STOP] | [CENTER] | [SPAN] hardkey
●
While in Cartesian diagrams the x-axis represents the stimulus values, in polar and
Smith diagrams this direct relation is lost. In any case, a marker can be used to dis-
play the stimulus value of a given trace point.
For "Time Domain" traces, points in the "observation interval" are interpreted as
stimulus values.
●
All stimulus settings except the "Time Domain X-Axis" settings are channel set-
tings. "Time Domain X-Axis" applies to the active (time domain) trace only.
Background information
Refer to the following sections:
●
Chapter 5.1.3, "Traces, Channels and Diagrams" , on page 81
●
Chapter 4.3.6.2, "Setting the Sweep Range" , on page 67
●
Chapter 4.3.6.6, "Set by Marker" , on page 69
6.8.1 Stimulus Tab
Defines the sweep range in the current channel, depending on the sweep type.
Related Settings
Refer to the following sections:
●
Chapter 5.1.4.3, "Stimulus and Sweep Types" , on page 88
●
Chapter 6.10.2, "Sweep Type Tab" , on page 396
Stimulus Softtool