GUI Reference
R&S
®
ZNB/ZNBT
695
User Manual 1173.9163.02 ─ 53
Table 6-7: Interface types for external power meters and address formats
Physical
interface
(connector)
Interface
(protocol)
Address
Remarks
LAN
VXI-11
<IpAddress>
for example
10.11.12.13
Full VISA resource string:
TCPIP[board]::<Address>[::INSTR]
SOCKET
<IpAddress>::<PortNo>
for example
10.11.12.13::50000
LAN connection with pure TCP/IP protocol;
refer to your VISA user documentation.
GPIB
GPIB0 ...
GPIB9
<Address>
for example
20
Full VISA resource string:
GPIB[board]::<Address>[::INSTR]
LAN or USB Other
Interface-specific, e.g. for SOCKET:
TCPIP0::<IpAddress>::<PortNo>::SOCKET
Use complete VISA resource string.
Remote command:
SYSTem:COMMunicate:RDEVice:PMETer<Pmtr>:DEFine
Auto Config
Causes the analyzer to clear the lists of "Known Devices" and "Configured Devices"
and to configure all R&S
NRPxxS/SN power sensors, detected at any of the USB
ports, automatically. No manual configuration is required.
Remote command:
SYSTem:COMMunicate:RDEVice:PMETer:CONFigure:AUTO[:STATe]
6.17.4.3
External Power Meter Config Dialog
Allows to modify configuration of certain external power meters, i.e. settings that are
persistently stored on the power meter (and NOT on the R&S
ZNB/ZNBT). This
requires the respective device to be online, i.e. connected, switched on and ready to
be used.
Access:
SYSTEM – [SETUP] > "External Devices" > "Power Meter Config..."
Setup Softtool
